Loctite Benchtop 300 ml Cartridge Pusher

The 98022 Benchtop 300 ml Cartridge Pusher is a designed for dispensing low viscosity product to high extrusion rate pastes. The cartridge pusher mechanically applies pressure to the cartridge plunger using a pneumatically driven ram. The pressure to the ram is set with the 0-60 psi pressure regulator. The regulator pressure should not be used above 50 psi, as the maximum cartridge rating is 60 psi and the ratio on the plunger is 1.1.
FEATURES:

• Since there is no high pressure air over the cartridge plunger, there is no opportunity for air ingress into the cartridge. The cartridge cylinder and ram are machined to tight tolerances to minimize the potential for skewing the cartridge plunger. A grease reservoir is included which continually applies a thin film of grease to the plunger shaft. If the cartridge cylinder was contaminated, this would prevent the shaft from being jammed (bonded).